Babel Buster BB2-7030 Line Termination
Termination and Bias jumpers for RS485 (MS/TP) on Control Solutions, Inc. Babel Buster BB2-7030
WARNING: Opening any electronic device for any reason including positioning of jumpers can cause damage or destruction of the device if proper ESD handling procedures are not followed! Refer to article on ESD Protective Measures regarding proper handling.
WARNING: Always remove power from device before opening it! This is for the protection of the device. You will not be harmed by the low voltage present, but you may cause damage or destruction of the device by opening it with power connected.
Note: Termination should only be applied at ends of RS485 link. Line bias, if used, should only be applied one place on the link.